(310) 878-0697Request an estimate
High pressure

Driveway pressure washing and concrete cleaning

Concrete is the one surface that can take full pressure. We clean driveways, walkways and garage aprons with a rotary surface cleaner so the finish comes out even, with no wand stripes, then treat oil, rust and tire marks one by one.

Request an estimate

What we clean

  • Driveways and aprons
  • Walkways and front steps
  • Garage floors
  • Side yards and trash areas
  • Curbs and parkway sidewalks
  • Oil, rust and tire marks

Why we use a surface cleaner, not just a wand

A wand held by hand leaves light and dark stripes on concrete, often called zebra striping, because the distance from the nozzle changes with every pass. A rotary surface cleaner holds the spray at a fixed height, so the whole slab comes out the same shade. Edges and corners get finished by hand.

Oil, rust and other stains

Pressure alone doesn't lift set-in oil. We pre-treat oil and grease with a degreaser, and rust from sprinklers or patio furniture with a rust remover made for concrete. Some old stains fade but won't disappear completely. We tell you which ones before we start, not after.

Where the dirty water goes

Water from a driveway runs downhill to the gutter, and the gutter drains straight to the ocean in the South Bay. Wash water with oil, soap or grit isn't allowed to go there. We block the drain path, collect the water and dispose of it the right way.

Driveway & Concrete Cleaning across the South Bay

We do driveway & concrete cleaning in Torrance, Redondo Beach, Manhattan Beach, Hermosa Beach, El Segundo, Palos Verdes Estates, Rancho Palos Verdes, Rolling Hills Estates, Lomita, San Pedro, Gardena and Carson.

Driveway & Concrete Cleaning: common questions

Can pressure washing remove oil stains from a driveway?

Fresh and moderate oil stains usually come out with a degreaser pre-treatment and hot or high-pressure rinse. Old stains that have soaked deep into the concrete often lighten a lot but may leave a shadow. We point those out before we start.

Does pressure washing damage concrete?

Not when the pressure and nozzle are right for the surface. Too much pressure up close can etch the surface or expose the aggregate. A surface cleaner at the right height cleans the slab evenly without cutting into it.

What causes the stripes left by some pressure washing jobs?

Stripes, often called zebra striping, come from cleaning a slab with a hand wand at an uneven distance. A rotary surface cleaner keeps the spray at one height, so the finish comes out even.

Do I need to move my cars?

Yes, please move cars off the driveway and out of the garage apron before we arrive. Plan for the concrete to stay wet for an hour or two afterward.

Request an estimate for your property

Tell us the address and what you need done. We review the property and send a written estimate before anything is scheduled.

CallRequest an estimate